ADITI

How do I update Power & Sleep Settings in Windows 10?
  • Click the Start button and select Settings.
  • Select System.
  • Select Power & sleep.
  • Update the Screen and PC Sleep settings as required.

------

How do I update UWF in Windows 10?


By default, Unified Write Manager [UWF] is set to Disabled in Windows 10. (UWF replaces EWF from Windows 7)

To update UWF:

  • Right-click over the Start button and select Control Panel.
  • Select Thinlabs UWF Manager (32-Bit).
  • Click Yes to allow the program to make changes.
  • Update the Current State to either Disabled or Enabled.
  • After updating, click OK at the reboot required prompt.
  • Reboot the system.

-----

How do I enter / exit BIOS on my Dualcore system?


Press 'F2' to enter BIOS and 'F10' to exit BIOS on Thinlabs Dualcore-based systems (TL2100, TL2200, TL6000, TL7400, TL8300, TL8400 models).

----

No Operating System is loading up

Is the storage device detected?  Start up the system and go into BIOS.  Check the Boot menu to see if the proper disk is detected.

  • If No, then the disk is defective - request an RMA for replacement.
  • If Yes, then exit BIOS, and at the GRUB menu, check to ensure the proper OS is being loaded.  If the OS quits while loading, contact your company's support team for instructions on how to reimage your system

-----

System will not turn on, battery partially charged


If the battery on your ADITI Mobile Computer for Medcarts is partially charged, and the system is not turning on, try the following:

  • Unplug the battery.
  • Press the reset button.
  • Plug the battery into the battery charger (DO NOT PLUG THE CHARGER INTO THE COMPUTER).
  • Charge the battery to full strength (this could take up to 5 hours).
  • Reconnect the battery to the system.

-----

Pages